Filter by:
Sort by:
How much on average would it cost to install an extraction hood. We have an existing hood (and electrical source) in place but no extraction vent?
I want to completely remove an old electric bar heater from my bathroom wall for tiling and don't want to reconnect anything, is it safe to cut the wires, tape them and then push them back through the wall?
Hi, i want to run an armoured cable from my garage consumer unit (which is fed from the main house consumer unit) to a garden room that would also have a consumer unit fitted to run LED lighting and small 13A power, is this an acceptable approach or can you not link consumer units? Thanks
I am having a new kitchen and the layout will be slightly different. Can l change a double socket to a cooker point and vice versa without having new wiring ?
I would like to install more switches at two different doorways within the same large room. Ideally both switches could be used independently of each other without any conflict. Is it feasible for me to install the additional switch and make adjustments by myself or is this more for a professional electrician to complete? In either case, is it likely that I will need to repaint or plaster around the switches afterwards? Any advice on this project would be great!
RCD unit 65-80A. 28kw total equipment output (Ranger cooker 16kw, microwave 2500kw, fryer 2 X 3kw, electric griddle X 3kw etc although the range cooker will not all be switch on- so average total output could be 18-23kw Will I need a new Consumer unit with 100a or can my old unit just need it's fuse changing? will all the wiring needs replacing w/ a thicker ones. Will it need 16.0mm wire (to accomodate total output) if the wire touches wall/ceiling but contained in a trunk/pvc pipe? How much time/estimated cost for this work?
Hi My contractor said he needed to remove some floor to run wires He pulled out the ENTIRE floor. Every single board in every room Surely this is not correct ? They now want to sell new floors to me
Hi guys, I am soon to be moving house and I have a small kitchen with a big full length cupboard which houses an RCD. I would like to utilise the cupboard by placing a washing machine or fridge in there and I also believe the RCD needs up dating. Can you tell me if this is possible please, I.e. utilising it for the washing machine or fridge or can i only use it for other storage items.
How much is it to replace old main fuse box which is under the stairs?
How much should it cost to fully re wire a 2 bed bungalow approximately
Are you looking for advice on a DIY project or have a question for our tradespeople?
We'll email your question to tradespeople who are skilled in your chosen category.
{{ first(ask.errors)[0] }}
Over 1 million homeowners and over 50,000 tradespeople
use MyJobQuote nationwide each year